If the rollers or other parts seem stuck, you can try brushing on some kerosene to the parts. If they are rusty, use steel wool to take away the rust and lubricate as usual. If they are badly corroded they may need replacement. You also need to take a look at the opener. If it is operated by a drive screw or a chain, you may need to lubricate these parts as well.
However, if this doesn't happen, you shouldn't think that you need garage door repair, but you shouldn't force the opener either. In case you go on hitting the button, it is possible that you will end up with a burned out motor, stripped gears or broken coils. Instead, you will have to do the work. Use a blow drier or heat gun to melt the ice.
Does it need Some Adjusting? ; Check the sides of the doors for any weather stripping. You may need to adjust the doors as necessary in order to have your unit working properly again. If the door of your garage is wood, make sure that it has weather stripping. If not, apply weather stripping on the bottom. Touch-ups may be necessary at this point, so that your wooden door doesn't get stuck again.
They are resistant to sagging over time, and will not warp due to time. Steel will also hold in heating and air much better than other garage doors. There are also specific openers that are sold for steel garage doors because they can be relatively heavy to an aluminum or wood application. Aluminum and wood doors are very cost efficient and do not require a high horsepower motor to raise them and close them.
garage door repair cost
repairing garage door roller
repairing garage door spring